Canon com ijsetup Help – step-by-step for Canon Printer Setup – canon / jsetup web download and full installation. If you are having trouble downloading, setting up, or installing a Canon printer model, we provide independent assistance. When you add a Canon printer to your device, the machine would automatically load a motor. However, if it is an older device (such as Windows XP or earlier), the machine may need the driver to be enabled before it can identify the connected printer. If the CD is no longer usable, the Canon printer driver can be loaded from another source.
top of page
Sony Android TV Forum - Android Smart TV Issues and Problems
This is your space to log any issues with your Sony Android TVs. Smart TV problems might be related to
-
Sony Android TV apps not working
-
Smart TV Apps download
-
Issues with new Sony TV first time setupI
-
Troubleshooting TV errors
-
Improved TV performance - TV Best practices
-
TV slow - Speed up Android TV
-
Best picture and sound settings for your Sony Smart TVs
-
Sony Bravia TV Guide
-
Any other Android TV related queries
Use this forum to raise any Android Smart TV related issues / problems or questions and we will answer them for you
bottom of page
Prepare the Printer
Place the printer on a flat and horizontal surface, and do not place any objects in front of the printer. Open the Rear Tray and extend the Paper Support. Open the Front Tray, and extend the Output Tray Extension.
Plug the power cord in the back of the printer and connect the other end to the wall outlet.
Press the POWER button to turn on the printer.
Open the Top Cover(A). The Print Head Holder moves to the center.
Install the Print Head
Remove the Print Head from its package.
Remove the orange protective cap(A) from the Print Head and discard it.
Firmly raise the Print Head Lock Lever until it stops. The Print Head Lock Lever may feel heavy.
Insert the Print Head.
Push the Print Head to hold it in place, and lower the Print Head Lock Lever carefully.
Make sure that the Print Head is installed correctly.
Install the Ink Tanks
Pull the orange tape in the direction of the arrow to peel off the protective film and remove the film completely.
Twist off and discard the orange protective cap(B) located on the bottom of the ink tank.
Insert the ink tank into the right-hand slot and press the [PUSH] mark on the ink tank until it clicks into place.
Make sure the ink lamp lights red.
Close the Top Cover.
Hardware setup is complete.
Hope You Find This Useful,
Peter